Starite 20DOM05221+1 - Bottom Suction - Cistern - Effluent Submersible Pump - 20 GPM - 1/2 HP - 230V

$575.00
In stock
SKU
20DOM05221+1
Starite 20DOM05221+1 - Bottom Suction - Cistern - Effluent Submersible Pump - 20 GPM - 1/2 HP - 230V is available to buy in increments of 1
• Manufacturer: Pentair • Brand: Starite • Series: Dominator Series - 4" Bottom Suction • MPN: 20DOM05221+1 • Horsepower: 1/2 HP • Voltage: 230 Volts • Maximum Amperage: 5.3 amps • Motor Wires: 2-Wires ( + Ground Wire ) • Requires Control Box: No • Phase / Hz: Single Phase / 60 Hz • Cord Length: 10 Feet Performance Rated • GPM Rated: 20 GPM • TDH (Total Dynamic Head Rated): 110 TDH • PSI Rated: 47 PSI
STARITE® DOMINATOR SERIES - 4" Bottom Suction Submersible Pumps Starite Dominator pumps are built on a ½ HP legacy of delivering water when and where you need it for aerobic, cistern & filtered effluent service applications.

STARITE® DOMINATOR - Product Highlights • SUPERIOR “PUMP-DOWN” CAPABILITY: The Dominator leads this class with the lowest draw-down of 4.5” (a standard 4” NEMA submersible only draws down to 13.5) • IMPELLERS: Precision molded for perfect balance...ultra smooth for the highest performance and efficiency. Allows for .080” solids. • REDUCED AMP DRAW: Over 25% less amp draw (9.5 amps vs. 12.7 amps, 115 volt)than a 4” NEMA submersible, reducing operating costs and extending the service life of float switch contacts • SHELL: Corrosion resistant 300-grade stainless steel • SignaSeal™ Internals: Utilizes a patented ceramic wear staging system surface for class-leading performance, superior sand handling, and a thrust management staging system with industry exclusive “dry-run” capabilities STARITE® DOMINATOR - Typical Uses • Effluent • Cistern • Tank Transfers • Aerobatic • Irrigation STARITE® DOMINATOR - Materials of Construction • Motor – Available in both 115 or 230 volt versions. Dry-wound, double ball bearing, double-sealed, with thermal overload protection, UL and CSA approved. • Shell – Stainless steel (300 grade) • Discharge – 1-1/4” Fiberglass- reinforced thermoplastic • Discharge Bearing – Nylatron® • Impellers – Acetel • Diffusers – Polycarbonate • Suction Caps – Polycarbonate with stainless steel wear ring • Thrust Pads – Proprietary spec. • Shaft and Coupling – Stainless steel 300 grade • Intake – Fiberglass-reinforced thermoplastic • Intake Screen – Stainless steel • Jacketed Cord – 300 Volt “SJOW” jacketed 10’ leads, 2-wire with ground • Agency Listing – UL and CSA

More Information
Total Dynamic Head (TDH) 75 to 100 (TDH), 100 to 125 (TDH), 125 to 150 (TDH)
Motor Wires ( 2W or 3W ) 2W ( 2-Wires + Ground )
Impeller Type Standard Impellers
Pump Diameter 4-Inch
Horsepower Rated 1/2 hp
GPM Range 16 to 20 gpm
Voltage 230 Volt
Brand StaRite
Featured Product No
Copyright © 2007 - 2022 Supreme Water Sales - The Clear Choice - All rights reserved.